Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterHow Much Does Door Installation Cost in Washington Park, FL?
A new entry door in Washington Park typically runs $1,800 to $4,600 installed, depending on whether you’re replacing a slab inside an existing frame or doing the full-frame tear-out most CBS homes here require. Impact-rated doors, which Broward County code mandates for most replacements, add roughly $800 to $1,500 over a standard inland door. Storm doors run $400 to $1,100, and custom arched doors start around $3,200. Call (754) 238-2201 for a line-item quote on your specific opening.
Salt Air Decides the Hardware Before We Ever Measure the Opening
Washington Park sits close enough to the Atlantic that salt-air corrosion is the quiet destroyer of door hardware. We pull corroded single-panel aluminum doors off mid-century CBS homes here every month. What fails first isn’t the slab. It’s the hinges, the threshold screws, the strike plate, and the jamb itself. On a 1960s CBS home off NW 46th Ave, our crew removed an entry door whose aluminum jamb had bowed so badly from oxidation that the deadbolt hadn’t aligned in years. The homeowner had been told twice it was just an old door that stuck. What we found was structural.
That job set the pattern for how we quote doors in Washington Park. We specified a fusion-welded impact-rated door with hot-dip galvanized hinges and stainless steel fasteners, then sealed the rough opening with flashing tape before setting the new pre-hung unit. The inspector passed it on the first visit. That’s the difference between a door that lasts five years here and one that lasts fifty. Salt air is the deciding factor on materials, and most quotes written for inland Fort Lauderdale blocks don’t account for it.
This is what we mean when we say Washington Park’s housing stock turns every door replacement into a structural decision. The mid-century CBS homes here were built with jalousie windows and lightweight aluminum-frame doors. Those original openings were never flashed properly, the frames were never coated for marine exposure, and the fasteners were plain steel. When we quote a door in Washington Park, we’re quoting a corrective install, not a swap.
Key takeaways for Washington Park homeowners:
- Impact-rated glazing is code-mandated on replacements, so most jobs are full-frame tear-outs, not slab swaps.
- Salt-air corrosion means stainless or hot-dip galvanized hardware is non-negotiable if you want the door to last.
- Original jalousie sidelights adjacent to entry doors fail impact code and force whole-opening replacement.
- A cheap inland-spec door installed with plain steel hinges will bind and corrode within five years here.
Why TruePane Windows & Doors Is Who Washington Park Calls for Door Installation
Dale Kessler founded TruePane in 2008, but the trade runs back further. Years of glazing and fenestration work in South Florida, with the same rule on the board since day one: if the pane is not true, the job is not done. That applies to every door slab, every jamb, every hinge leaf, every piece of flashing. Washington Park homeowners call us because we specify materials for what the coast actually does to a door opening, not for what looks fine at the showroom.
We answer the phone with a live person, around the clock. Not a voicemail tree, not a callback form. When you call (754) 238-2201, you talk to someone who knows what a CBS rough opening looks like and can tell you whether your jalousie sidelight is going to trigger a full tear-out before we ever roll a truck. Our technicians are background-checked, uniformed, and trained the way Dale trained: measure twice, quote manufacturer lines side by side on paper, register both warranty layers in writing before we leave the driveway.
Every job carries the Done Right Promise on top of The Keystone Standard. Both manufacturer warranty layers get registered in writing, durations stated plainly. If something isn’t right, we make it right. No paperwork fights, no arguing about fine print. That’s not a slogan. It’s how we’ve worked for years.
Our Door Installation Services in Washington Park
Entry & Swing Doors
Most entry doors we install in Washington Park are impact-rated replacement units set into CBS walls that haven’t been touched since the Eisenhower administration. The original aluminum frame is usually corroded beyond saving, which is exactly why Broward County code pushes these jobs into full-frame territory. We tear out the old unit, flash the rough opening correctly, and set a pre-hung door that actually latches in a rainstorm. Expect $1,800 to $3,900 for most single entry doors, more for custom glass or oversized openings.
Storm Doors
A storm door on a Washington Park home does double duty: it takes the brunt of wind-driven rain off the entry door while letting the sea breeze through in the shoulder seasons. But if your existing entry has jalousie panels beside it, the storm door alone won’t bring the opening up to code. We’ll tell you that before you spend the money. Quality storm doors with minimal-maintenance finishes start around $400 installed and run up to $1,100 for impact-rated or custom-fitted units.
Arched & Custom Doors
Washington Park has a surprising number of arched entry openings on the 1950s and 1960s custom CBS homes, and those openings don’t take an off-the-shelf slab. We measure, template, and order the door to the actual radius of the arch. Custom arched doors start around $3,200 and go up based on glass, wood species, and impact rating. The work is slower, and the price reflects the fuller process from templating to final trim.
Bifold & Folding Doors
Folding door systems show up more on patio and lanai openings in Washington Park, where homeowners want to open the back of the house to the yard without dealing with a sliding track. Salt-air corrosion plays here too: the carriage hardware and hinges need marine-grade or stainless components or the door binds within a few seasons. We quote bifold and folding door installs at whatever the manufacturer line specifies, plus the hardware upgrade the coast actually demands.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Washington Park
We’re an authorized installer for more than a dozen manufacturer lines, including, ES Windows, and ECO Window Systems. When you sit down with our team for a door quote in Washington Park, you see manufacturer options side by side on paper: glass package, frame material, U-factor, impact rating, warranty term. No hand-waving. We register both warranty layers in writing before we leave, so there’s no question about who stands behind the door in year seven. We stock common hardware and replacement components for those lines in our South Florida service area, which means faster turnaround when a hinge or threshold needs replacement rather than a full new door.
Common Door Installation Problems We See in Washington Park Homes
- Salt-air pitting on aluminum frames and hinges. Uncoated aluminum door frames near the coast start showing white powdery corrosion within five years. The hinge leaves seize, the door binds on the latch side, and the threshold seal tears from the door dragging across it.
- Jalousie sidelights failing impact code. Original louvered-glass panels beside the front door can’t take impact film and can’t be partially upgraded. Once the inspector is involved, the whole opening gets torn out and replaced with impact-rated glazing and a new pre-hung door.
- Wind-driven rain intrusion at poorly flashed jambs. The original CBS rough openings were never flashed with modern materials. Water gets behind the jamb, rots the wood bucks set into the block, and the door sags until the latch misses the strike plate entirely.
- Slab swaps attempted into 1950s frames. We see this on older Washington Park blocks regularly. Someone hung a new slab in a corroded aluminum jamb from 1962. Within two years the frame is the problem, and now the code-triggered tear-out is more expensive than doing it right the first time.
Pricing for Door Installation in Washington Park, FL
Here’s what Washington Park homeowners should expect to pay, honestly stated.
- Standard entry door replacement (slab only, existing frame): $900 to $1,800
- Full-frame impact-rated entry door (most common here): $2,400 to $4,600
- Storm door, installed: $400 to $1,100
- Custom arched entry door, impact-rated: $3,200 to $7,500+
- Bifold or folding patio door system: $2,800 to $9,000 depending on configuration
The premium for an impact-rated door over a standard inland door in Washington Park runs $800 to $1,500 on average. That’s not markup. That’s the cost of laminated glass, a reinforced frame, and the testing the door has to pass before it can carry an impact sticker for Broward County permitting. The cheaper inland door that gets installed without impact glazing won’t pass inspection here, and a door that does pass but gets plain steel hinges will corrode and bind within five years. The cheap spec costs more within a decade. Call (754) 238-2201 and we’ll put a fixed line-item quote in writing before you decide anything.
We Also Serve Cities Near Washington Park
Our Door Installation crews work throughout the broader Broward and Central Florida corridors, including Anna Maria, Acacia Villas, Alafaya, and Altamonte Springs. If you’re just outside Washington Park, give us a call and we’ll confirm coverage. Same standards, same Done Right Promise, same live person answering the phone at (754) 238-2201.
Serving Washington Park, FL - Our Local Coverage Area
We’re based in the Washington Park area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Door Installation in Washington Park
Yes. Broward County requires a permit for exterior door replacement on CBS homes, and the replacement door must meet hurricane-impact-rated glazing standards under the current Florida Building Code. We pull permits, schedule inspections, and handle the paperwork so the job passes on the first visit. Call (754) 238-2201 and we’ll explain the exact permit path for your opening before we quote anything.
You can try, but the frame is the problem by now. Washington Park’s salt air has spent sixty years oxidizing that aluminum jamb, and the hinge screw holes are likely stripped or corroded beyond reliable fastening. More importantly, Broward County code triggers impact-rated requirements on replacement doors, which means the old frame won’t pass inspection anyway. A slab hung in a failing frame is a two-year stopgap here, not a fix.
Salt air pits uncoated aluminum and plain steel within three to five years. Hinges seize, screws shear, strike plates loosen, and the door starts binding. We specify hot-dip galvanized or stainless steel hinges and fasteners on every coastal install, and we seal the rough opening with flashing tape before setting the pre-hung unit. That hardware upgrade costs a little more upfront and is the difference between a five-year door and a fifty-year door. Call (754) 238-2201 for a quote that specifies exactly what hardware you’re getting.
You can, but it won’t solve the bigger problem. The jalousie panels beside the entry don’t meet impact code, so adding a storm door to that opening doesn’t bring the whole assembly into compliance. When the opening is eventually permitted for replacement, you’ll likely need a full tear-out of the jalousie panels and the original frame, with impact-rated glazing installed alongside the new door. We’ll tell you straight what triggers the full opening replacement and quote both paths if you’re weighing a temporary fix.
An impact-rated front door in Washington Park runs roughly $800 to $1,500 more than a standard inland door of the same style. The increase covers laminated impact glass, a reinforced frame, stainless or galvanized coastal hardware, and the testing certification required for Broward County permitting. A standard inland door installed here will fail inspection, and even if it got past, salt air would eat the hardware in five years. The upfront savings don’t hold. Call (754) 238-2201 and we’ll put both options in writing side by side so you can see the real numbers.
Call TruePane for Door Installation in Washington Park
If you live in Washington Park and your front door binds in July, or the threshold is lifting, or the jalousie sidelight next to the entry is fogged and rattling in the wind, call us at (754) 238-2201. We’ll schedule a free estimate, measure the opening twice, and give you a fixed line-item quote with materials specified for a coastal CBS home. Not an inland door with coastal ambitions. The right door, the right hardware, the right flashing, done right. That’s the standard. Dale wouldn’t have it any other way.
Written by Dale Kessler, Owner at TruePane Windows & Doors, bringing years of glazing and fenestration craft to Washington Park and the surrounding South Florida communities.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.